DFS-3-W日本ASK流量传感器适用溶于水的冷却剂或工业用水   DFS 系列 产地: 日本 型号: DFS-3-W A single unit offers three functions: Flow Switch, Flow Sight, and Flow Meter.

• Features This sensor has a seven-segment LED digital display to make you read flow rate value easily. You can select one of two different kinds of output types: PNP output or NPN output. This sensor is used with a connector (M12×4-pin). You can use the digital flow sensor with an b power supply of from 12 to 24 V DC (permissible voltage fluctuation ±10 %). The amplifier protection structure conbs to IP67 equivalent. You can set the lower limit of the flow rate. If the flow rate falls below this limit, the red LED lamp (NG) turns on, and contact signal output is given to notify the operator of the critical situation. In the case of low pressure specifications, you can check the flow of fluid by observing the rotor rotation. You can use the sensor at the desired installation b (horizontal, vertical, or tilted b) and in the desired inflow direction. Rotor can be cleaned by air removing the cap from the front of the main body.

  Type

  DFS-3-W-*
  	Model	Digital flow sensor
  	Screw diameter (for both sides)	1 : Rc1/8 2 : Rc1/4 3 : Rc3/8 6 : Rc3/4 8 : Rc1
  	Applicable fluid	O : Hydraulic oil, lubrication oil (DFS-1: Only O type) W :Water, water soluble cutting oil
  	Custom specification	Please ask us.

  Example of use

  • Seizure can be avoided by flow control of lubricating oil for the spindles and bearings of machine tools, printing machines, presses and speed reducers.
  • Tool damage and fire can be prevented by control of coolant flow to machine tools.
  • This sensor is used to check if the filter is clogged or not.
  • Coolant flow control.DFS-3-W    日本ASK流量传感器适用溶于水的冷却剂或工业用水

  Body and overall Specifications

  Type	DFS-1	DFS-2	DFS-3	DFS-6	DFS-8
  Connection diameter	Rc1/8	Rc1/4	Rc3/8	Rc3/4	Rc1
  Maximum Flow Rate ( ?/min)	1	10	20	50	100
  Measurement Range ( ?/min)	0.2∼1	1∼10	2∼20	5∼50	10∼100
  Maximum Pressure (MPa)	3	3 (if a bl/plastic cap is installed) 25 (if an all-bl cap is installed)
  Flow Sight Function	Available	Available (if a bl/plastic cap is installed) Not available (if an all-bl cap is installed) ※1
  Accuracy (?/min)	±0.1	±0.5	±1.0	±2.5	±5.0
  Applicable Fluid ※2	Hydraulic oil, Lubrication oil	Hydraulic oil, Lubrication oil Water, Water-soluble cutting oil
  Pressure loss ※3	> 0.03MPa	> 0.025MPa
  Temperature	0～80 ℃ (Fluid) 0～50 ℃ (Ambient temperature)
  Material (Fluid contact part)	C3604 (Ni Plating),Nd-Fe-B,POM,PC,NBR (DFS-1: C3604→SUS304)

  
  Amplifier specifications

  Power source	DC12～24 V (permissible voltage fluctuation ±10 %)
  Current Consumption	Maximum 100 mA
  Output	NPN open collector (factory setting) /PNP open collector. Maximum load 100 mA
  Connection	M12X1-4-pin connector (DC)
  Degree of Protection	IP67 equivalent
  Material (outside)	ABS, NBR, PA, and POLYESTER
  Display ※4	Seven-segment LED (Green/Red)
  Output state ※5	More than adjusted value : LED (Green) ON / LED (Red) OFF Less than adjusted value : LED (Green) OFF / LED (Red) ON
  Connector ※6

  ※1：	You can not see fluid if the bl cap (for high pressure) is installed.
  ※2：	We adjust each type of sensors at our factory in accordance with fluid type. Please specify the type of fluid you intend to use the sensor with when you place your order.
  ※3：	Value for Max. Flow rate at viscosity 32 cSt.
  ※4：	You can select the non-display mode.
  ※5：	You can configure alarm flow rate optionally. See the DFS instruction manual on how to configure.
  ※6：	We also sell a single article of sensor cable. Please ask us, for details.

  Principle of actuation

  
  The detection part of digital flow sensor utilizes rotation of the rotor (turbine) installed in the passage. The measuring part detects, by means of the external magnetic sensor, the rotational speed of the permanent magnet mounted on the circumference of the rotor.
  You can select NPN output or PNP output optionally.

  DFS-3-W日本ASK流量传感器适用溶于水的冷却剂或工业用水